Billet Machined 1/10 VFX2.2 Roll Cage Type Trail Racer 4WD Scale Crawler ARTR

See More Product review for Billet Machined 1/10 VFX2.2 Roll Cage Type Trail Racer 4WD Scale Crawler ARTR

Customer product review

based on 1 review

Very happy

4.0 rating

First off the quality is overall great. One thing I would like to note though is that the front of the frame bumper area hits the servo just before full shock compression. Have not found a working solution just yet for this issue. Lowering is not an option due to this. I know that many like to lower there rigs. As long as this is used as a crawler I do not see this being a problem for most unless lowering. I may mod the frame, get a new one or even just build another down the road to make the adjustment. I was going to build piece by piece and found that it would cost over twice as much for the same parts more or less so a few changes in parts still make it worth it. Also with this you must go over every nut, bolt screw and even lube internal gearing. I used thread locker CA glue and even epoxy which was used on the lower links where the plastic meets the metal rod. Yes there is some plastic but very little. Mainly at the joints for the linkages on the steering and four link. I would go over everything then run it as it was intended then go over everything again looking any issues. Overall this was well worth it and I would buy again.